您的位置:主页 > 道闸资讯 >

「鹤岗道闸」道闸弹簧调节

日期:2019-08-09 15:56

鹤岗道闸道闸弹簧调节

 

1. 打开道闸箱门,向中间扳动箱体内部下方的道闸帽子压紧扳手,使道闸帽子挂勾脱落,取下道闸帽子


Open the gate of the sluice box, pull the cap of the sluice under the inner part of the box to press the wrench, so that the hook of the cap of the sluice will fall off and the cap of the sluice will be removed.



2.在主轴弹簧连杆垂直轴上有2-3根弹簧连接螺栓示

 

There are 2-3 spring connection bolts on the vertical axis of the spindle spring connecting rod.



3.根据道闸杆增加或减少的重量或长度,先调整弹簧数量,再调整弹簧连接螺栓螺母

According to the increase or decrease of the weight or length of the gate rod, first adjust the number of springs, and then adjust the spring connecting bolts and nuts.


 

双鸭山道闸

 


增加重量,须顺时针方向拧紧螺母,以增加弹簧拉力

 

To increase weight, the nuts must be tightened clockwise to increase spring tension.


减轻重量,须逆时针方向拧松螺母,以减小弹簧压力

Reduce weight by loosening nuts counterclockwise to reduce spring pressure



调整时,每个螺母旋转圈数应相同,以免弹簧受力不均衡。

When adjusting, the number of revolving rings of each nut should be the same, so as to avoid uneven force on the spring.


4.松开离合,将道闸杆置于45度位置时,若道闸杆不会动,则调平衡了

When the clutch is loosened and the gate rod is positioned at 45 degrees, if the gate rod does not move, the balance is adjusted


若档杆会向上运动,则需再拧松螺母

If the gear rod moves upward, the nut needs to be loosened again


若档杆向下运动,则需再拧紧螺母,直至平衡为止

 

If the gear rod moves downward, the nut needs to be tightened again until it is balanced



5.调整完毕后,再将两个螺母锁紧

 

After adjustment, lock the two nuts


 

哈尔滨创隆,欢迎您.